|
Cisco Command |
Juniper Command |
Co-Ordinating Definition |
|
show ip interface brief |
show interface terse |
displays the status of interfaces configured for IP |
|
show interface [intfc] |
show interfaces [intfc] detail |
displays the interface configuration, status and statistics. |
|
show controller intfc |
show interfaces intfc extensive |
displays information about a physical port device |
|
show interface | incl (proto|Desc) |
show interfaces description |
displays the interface configuration, status and statistics |
|
show ip route |
show route |
displays summary information about entries in the routing table |
|
show ip bgp summary |
show bgp summary |
displays the status of all Border Gateway Protocol (BGP) connections |
|
show ip bgp net mask |
show route protocol bgp prefix |
will show you how that route is being advertised, look for the first line |
|
show ip bgp net mask longer-prefixes |
show route range prefix |
will show you how that route is being advertised, look for the first line |
|
show ip bgp regexp AS-regexp |
show route aspath-regexp "AS-regexp" |
displays routes matching the autonomous system (AS) path regular expression |
|
show ip bgp neighbors neigh received-routes |
show route receive-protocol bgp neigh |
Shows whether a neighbor supports the route refresh capability |
|
show ip bgp neighbor neigh advertised-routes |
show route advertising-protocol bgp neigh |
Shows whether a neighbor supports the route refresh capabilty |
|
show clns neighbors |
show |
displays both ES and IS neighbors |
|
show clns interface |
show |
shows specific information about each interface |
|
show ip route |
show |
displays the current state of the the routing table |
|
show |
show |
displays a list of all connected routers in all areas |
|
show ip ospf interface |
show ospf neighbor |
shows neighbor ID, Priority, IP, & State if the neighbor router, dead time. |
|
show ip ospf interface |
show ospf interface |
shows neighbor id, pri, state, dead time, address and interface |
|
show ip route ospf |
show ospf route |
display the current state of the routing table |
|
show ip ospf database |
show ospf database |
display list of information related to the OSPF database for a specific communication server |
|
show version |
show version, show system uptime |
display the system hardware config., software version, and name and source of configuration files and boot images |
|
show diags |
show chasis hardware |
displays power-on diagnostics status |
|
show processes cpu |
show system process |
displays utilization statistics |
|
show tech-support |
request support info |
displays the current software image, configuration, controllers, counters, stacks, interfaces, memory and buffers |
|
show logging |
show log messages |
display the state of logging to the syslog |
|
show route-map name |
show policy name |
displayall route-maps configured or only the one specified |
|
show ip prefix-list name |
show policy name |
display information about a prefix list or prefix list entries |
|
show ip community-list list |
configure, |
display routes that are permitted by BGP community list |
|
show environment all |
show chassis environment |
displays temperature and voltage information on the console |
|
ping dest |
ping dest rapid (for cisco like output) |
to check to see if a destination is alive |
|
ping (setting source int) |
ping dest bypass-routing |
to check to see if a destination is alive |
|
terminal monitor |
monitor start messages |
Change console terminal settings |
|
terminal no monitor |
monitor stop |
Change console terminal settings |
|
terminal length 0 |
set cli screen-length 0 |
sets the length for displaying command output |
转载地址：http://www.net130.com/CMS/Pub/Tech/tech_zh/2006_12_04_39875.htm
